key_casting
[[http://www.alumilite.com/|Alumilite]] Key Casting
<!–thumb|left|alt=Orignal key in RTV mold compound|First step. Abloy key in RTV mold compound.
thumb|alt=Epoxy resin setting in mold.|Second step. Epoxy resin setting in mold.
thumb|left|alt=Block of expoxy and RTV silicon.|Third step. Pulled casting and mold from shell.
thumb|alt=Plastic key casting.|Working key casting.–>
<gallery widths=`160px` heights=`160px`> Image:Making_mold.jpg|First step. Abloy key in RTV mold compound. Image:Casting.jpg|Second step. Epoxy resin setting in mold. Image:Pulled_casting_mold.jpg|Third step. Pulled casting and mold from shell. Image:Finished_casting.jpg|.|Working key casting. </gallery>
<!– mold release, heat mold, cure time, pot time, harden over night, bubbles, vib table air channel –>
key_casting.txt · Last modified: 2013/08/13 12:13 by 127.0.0.1
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
