stencil
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | stencil [2013/08/13 12:13] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== Making a Stencil on the CNC or Laser ===== | ||
+ | |||
+ | |||
+ | Load eagle, view the tCream/ | ||
+ | |||
+ | ==== CNC ==== | ||
+ | For the CNC Mill, export the gerber with the right CAM job, get the GTP/GBP layers and import into PhCNC. as top /bottom stencil. | ||
+ | |||
+ | Bond some 3mil brass sheets to a PCB FR4 with spray mount adhesive. Use a drewtronics 30o bit @60000RPM, test cut 4-8mil (7mil) tool tests to make sure the stencil is cut properly. | ||
+ | |||
+ | Cut stencil, check with camera. buff with scotchbrite green, remove and use flux remove to gently lift away the brass stencil, do not stress it. | ||
+ | |||
+ | |||
+ | ==== Laser ==== | ||
+ | |||
+ | For the Laser, export the gerber with the HPGL CAM job, get the tCream or bCream layer and import into LaserCut as PLT | ||
+ | |||
+ | [[media: | ||
+ | |||
+ | |||
+ | use mylar or frisk sheets | ||
+ | |||
+ | |||
+ | |||
+ | Attach to frame and paste! | ||
+ | |||
+ | arclight did a fancy page [[Laser Stencils]] | ||
stencil.txt · Last modified: 2013/08/13 12:13 by 127.0.0.1