User Tools

Site Tools


l12014_proxmark3_oled_build

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
l12014_proxmark3_oled_build [2014/08/27 20:53]
blakangel photo of jumper wire
l12014_proxmark3_oled_build [2014/08/27 20:57] (current)
blakangel [Notes] photo
Line 51: Line 51:
  
 You need to install a jumper wire for the MOSI signal from the via near the buzzer to the correct pad of SJ1. Refer to the below photograph: You need to install a jumper wire for the MOSI signal from the via near the buzzer to the correct pad of SJ1. Refer to the below photograph:
-{{:​jumper-wire-proxmark-l1.png?200|}} +{{:​jumper-wire-proxmark-l1-cropped.png |}}
  
  
l12014_proxmark3_oled_build.txt · Last modified: 2014/08/27 20:57 by blakangel