This is an old revision of the document!

LayerOne 2014 Badge Build

Notes

Please use the following board/schematic and NOT the svn:

Start with the parts on page 1 and page 2 of the schematic.
Hold off on placing the battery and the switch until the end, as they go on the bottom.

Use hotair gun for IC1 and U&7.

Do not place (DNP) R55 and R60.

C9 should be a 0 ohm resistor (jumper).

R43 should be changed to 110K~120K, ask M for that part.

Jumper JP2 like so:

IC3 is now a 500ma part. CAT6219-330TDGT3 Do not use same part as IC13.