goodfet31
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | goodfet31 [2013/08/13 12:13] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | **BOM DigiKey** | ||
+ | < | ||
+ | *1 [[http:// | ||
+ | *1 [[http:// | ||
+ | |||
+ | Once again, you can get your MSP430 from the nice folks at TI: | ||
+ | |||
+ | |||
+ | Goodfet41 | ||
+ | http:< | ||
+ | |||
+ | |||
+ | * 2 x 0.1uF 0603 capacitors | ||
+ | * 1 x 330 Ohm 0603 resistor | ||
+ | * 1 x 300 Ohm 0603 resistor | ||
+ | * 3 x RED LED 0603 | ||
+ | |||
+ | |||
+ | Rest of the parts, except the header, are shared with the [[GoodFET31L]] | ||
+ | |||
+ | **Assembly Notes** | ||
+ | |||
+ | Should take about 30 minutes to assemble. | ||
+ | |||
+ | |||
+ | If you're using [[http:// | ||
+ | |||
+ | |||
+ | FT232, resistors, LED's and capacitors added | ||
+ | |||
+ | [[Image: | ||
+ | |||
+ | |||
+ | * Add FT232, tag corners or hot plate, check orientation. | ||
+ | * Add 0.1uF capacitors, can go around either way. | ||
+ | * Add 300 and 330Ohm resistors, can go around either way. | ||
+ | * Add 3 LEDs, check orientation. | ||
+ | |||
+ | |||
+ | Plug into a USB hub, Two LED's closest to the USB port should flash momentarily. If this works, plug it into a PC and the LED's should flash a couple of times more, and the PC should install drivers. | ||
+ | |||
+ | If it doesn' | ||
+ | |||
+ | [[http:// | ||
goodfet31.txt · Last modified: 2013/08/13 12:13 by 127.0.0.1