Differences

This shows you the differences between two versions of the page.

--- equipment:laser_cutter:upgrades [2023/01/17 19:42] – [Worn/dead parts that need replacing] nz0
+++ equipment:laser_cutter:upgrades [2023/08/22 10:27] (current) – [Installed and Upgraded!] nz0
@@ Line 9: / Line 9: @@
 |red dot pointer w/bracket installed        |
 |z autofocus sensor w/bracket installed      |
+|Mahoney CO2 Laser Power Meter Probe | (to measure how much power is actually coming out of our tube)|
+|1 pair 10600nm protective glasses          | $36 each pair|
+|ameter power usage meter            |
-==== Acquired but not yet installed ====
+^ Acquired but not yet installed ^|
 |RECI W2 Laser Tube                  | new tube is at the space - will install when the old tube fails|
 ^ upgrades/nice to haves ^Cost|
+|USB camera for lightburn            | $80 https://lightburnsoftware.com/products/lightburn-camera?variant=13886769889325|
 |quiet duct fan                      | $120|
-|10600nm protective glasses          | $36 each pair (the current ones are not for a co2 laser)|
 |Rotary tool (y axis replacement)    | $310  (So we can etch round things like glasses and tubes)|
-|ameter power usage meter            | ?|
 |laser on timer                      | ?|
-|Mahoney CO2 Laser Power Meter Probe | $105 (to measure how much power is actually coming out of our tube)|