equipment:laser_cutter:upgrades
This is an old revision of the document!
Wish List
Installed and Upgraded!
upgraded |
---|
new estop switch installed |
main power key switch installed |
Ruida Controller/control panel installed |
Lightburn software installed |
red dot pointer w/bracket installed |
z autofocus sensor w/bracket installed |
Acquired but not yet installed | |
---|---|
RECI W2 Laser Tube | new tube is at the space - will install when the old tube fails |
upgrades/nice to haves | Cost |
---|---|
quiet duct fan | $120 |
10600nm protective glasses | $36 each pair (the current ones are not for a co2 laser) |
Rotary tool (y axis replacement) | $310 (So we can etch round things like glasses and tubes) |
ameter power usage meter | ? |
laser on timer | ? |
Mahoney CO2 Laser Power Meter Probe | $105 (to measure how much power is actually coming out of our tube) |
equipment/laser_cutter/upgrades.1674014864.txt.gz · Last modified: 2023/01/17 20:07 by nz0