l12014_proxmark3_oled_build
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| l12014_proxmark3_oled_build [2014/08/27 20:53] – photo of jumper wire blakangel | l12014_proxmark3_oled_build [2014/08/27 20:57] (current) – [Notes] photo blakangel | ||
|---|---|---|---|
| Line 51: | Line 51: | ||
| You need to install a jumper wire for the MOSI signal from the via near the buzzer to the correct pad of SJ1. Refer to the below photograph: | You need to install a jumper wire for the MOSI signal from the via near the buzzer to the correct pad of SJ1. Refer to the below photograph: | ||
| - | {{: | + | {{: |
l12014_proxmark3_oled_build.txt · Last modified: by blakangel