equipment:laser_cutter:upgrades
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
equipment:laser_cutter:upgrades [2023/01/17 20:05] – [Acquired but not yet installed] nz0 | equipment:laser_cutter:upgrades [2023/08/22 10:27] (current) – [Installed and Upgraded!] nz0 | ||
---|---|---|---|
Line 9: | Line 9: | ||
|red dot pointer w/bracket installed | |red dot pointer w/bracket installed | ||
|z autofocus sensor w/bracket installed | |z autofocus sensor w/bracket installed | ||
+ | |Mahoney CO2 Laser Power Meter Probe | (to measure how much power is actually coming out of our tube)| | ||
+ | |1 pair 10600nm protective glasses | ||
+ | |ameter power usage meter | | ||
- | ==== Acquired but not yet installed | + | ^ Acquired but not yet installed |
|RECI W2 Laser Tube | new tube is at the space - will install when the old tube fails| | |RECI W2 Laser Tube | new tube is at the space - will install when the old tube fails| | ||
^ upgrades/ | ^ upgrades/ | ||
+ | |USB camera for lightburn | ||
|quiet duct fan | $120| | |quiet duct fan | $120| | ||
- | |10600nm protective glasses | ||
|Rotary tool (y axis replacement) | |Rotary tool (y axis replacement) | ||
- | |ameter power usage meter | ?| | ||
|laser on timer | ?| | |laser on timer | ?| | ||
- | |Mahoney CO2 Laser Power Meter Probe | $105 (to measure how much power is actually coming out of our tube)| | + |
equipment/laser_cutter/upgrades.txt · Last modified: 2023/08/22 10:27 by nz0