l12014_proxmark3_oled_build
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
l12014_proxmark3_oled_build [2014/08/27 20:51] – info about mosi jumper wire blakangel | l12014_proxmark3_oled_build [2014/08/27 20:57] (current) – [Notes] photo blakangel | ||
---|---|---|---|
Line 51: | Line 51: | ||
You need to install a jumper wire for the MOSI signal from the via near the buzzer to the correct pad of SJ1. Refer to the below photograph: | You need to install a jumper wire for the MOSI signal from the via near the buzzer to the correct pad of SJ1. Refer to the below photograph: | ||
+ | {{: | ||
l12014_proxmark3_oled_build.txt · Last modified: 2014/08/27 20:57 by blakangel