Differences

This shows you the differences between two versions of the page.

--- l12014_proxmark3_oled_build [2014/08/02 20:05] – [Notes] mmca
+++ l12014_proxmark3_oled_build [2014/08/27 20:57] (current) – [Notes] photo blakangel
@@ Line 46: / Line 46: @@
 Use the Silver SV2: {{:2014-08-02_20.00.50.jpg?250|}}\\
+Before installing the OLED display and battery, ensure the proxmark is properly working via USB by installing a jumper wire from F1 (PTC Fuse) to TP10 to provide 5V to the board. Plug into a computer and verify the correct USB VID/PID.
+This is also a good time to install required proxmark3 usb drivers and the proxmark3 application for your OS.
+You need to install a jumper wire for the MOSI signal from the via near the buzzer to the correct pad of SJ1. Refer to the below photograph:
+{{:jumper-wire-proxmark-l1-cropped.png |}}