l12014_proxmark3_oled_build
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
l12014_proxmark3_oled_build [2014/08/02 00:41] – [Notes] mmca | l12014_proxmark3_oled_build [2014/08/15 22:08] – info re testing before installing oled blakangel | ||
---|---|---|---|
Line 44: | Line 44: | ||
TP19 - 2v5\\ | TP19 - 2v5\\ | ||
TP20 - 1v2\\ | TP20 - 1v2\\ | ||
+ | |||
+ | Use the Silver SV2: {{: | ||
+ | |||
+ | Before installing the OLED display and battery, ensure the proxmark is properly working via USB by installing a jumper wire from F1 (PTC Fuse) to TP10 to provide 5V to the board. Plug into a computer and verify the correct USB VID/PID. | ||
l12014_proxmark3_oled_build.txt · Last modified: 2014/08/27 20:57 by blakangel