l12014_proxmark3_oled_build
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
l12014_proxmark3_oled_build [2014/07/21 18:44] – [Notes] mmca | l12014_proxmark3_oled_build [2014/07/27 00:18] – [Notes] mmca | ||
---|---|---|---|
Line 19: | Line 19: | ||
C9 should be a 0 ohm resistor (jumper).\\ | C9 should be a 0 ohm resistor (jumper).\\ | ||
- | R43 should be changed to 110K~120K, ask M for that part.\\ | + | R26 should be changed to 110K there is a reel in the box.\\ |
Jumper JP2 like so: {{: | Jumper JP2 like so: {{: | ||
Line 27: | Line 27: | ||
If using micro usb, place it now. If using mini usb, wait till later as it goes on the bottom.\\ | If using micro usb, place it now. If using mini usb, wait till later as it goes on the bottom.\\ | ||
- | To test main 3v3 rail, inject 5v in to 5V line at TP10. Once that checks out proceed to third page of schematic, and install the MCU (IC12) and the related parts.\\ | + | inject 5v in to 5V line at TP10, check at header pin for +3v3. , |
+ | |||
+ | Once that checks out proceed to third page of schematic, and install the MCU (IC12) and the related parts.\\ | ||
Dont install the buttons and speaker yet, as they go on the bottom.\\ | Dont install the buttons and speaker yet, as they go on the bottom.\\ |
l12014_proxmark3_oled_build.txt · Last modified: 2014/08/27 20:57 by blakangel