l12014_proxmark3_oled_build
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
l12014_proxmark3_oled_build [2014/07/20 21:23] – [LayerOne 2014 Badge Build] mmca | l12014_proxmark3_oled_build [2014/07/27 14:08] – [LayerOne 2014 Badge Build] mmca | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== LayerOne 2014 Badge Build ====== | ====== LayerOne 2014 Badge Build ====== | ||
{{ : | {{ : | ||
+ | |||
+ | Please use pick above for orientation (click for larger image).\\ | ||
Line 19: | Line 21: | ||
C9 should be a 0 ohm resistor (jumper).\\ | C9 should be a 0 ohm resistor (jumper).\\ | ||
- | R43 should be changed to 110K~120K, ask M for that part.\\ | + | R26 should be changed to 110K there is a reel in the box.\\ |
Jumper JP2 like so: {{: | Jumper JP2 like so: {{: | ||
Line 27: | Line 29: | ||
If using micro usb, place it now. If using mini usb, wait till later as it goes on the bottom.\\ | If using micro usb, place it now. If using mini usb, wait till later as it goes on the bottom.\\ | ||
- | To test main 3v3 rail, inject 5v in to 5V line at TP10. Once that checks out proceed to third page of schematic, and install MCU (IC12) and the related parts.\\ | + | inject 5v in to 5V line at TP10, check at header pin for +3v3. , |
+ | |||
+ | Once that checks out proceed to third page of schematic, and install | ||
Dont install the buttons and speaker yet, as they go on the bottom.\\ | Dont install the buttons and speaker yet, as they go on the bottom.\\ |
l12014_proxmark3_oled_build.txt · Last modified: 2014/08/27 20:57 by blakangel