Differences

This shows you the differences between two versions of the page.

--- l12014_proxmark3_oled_build [2014/07/19 15:47] – [Notes] mmca
+++ l12014_proxmark3_oled_build [2014/07/27 00:18] – [Notes] mmca
@@ Line 1: / Line 1: @@
 ====== LayerOne 2014 Badge Build ======
+{{ :2014-06-26_22.26.30.jpg?direct&500 |}}
@@ Line 17: / Line 19: @@
 C9 should be a 0 ohm resistor (jumper).\\
-R43 should be changed to 110K~120K, ask M for that part.\\
+R26 should be changed to 110K there is a reel in the box.\\
 Jumper JP2 like so: {{:2014-07-17_15.43.50.jpg?link&200|}}\\
@@ Line 25: / Line 27: @@
 If using micro usb, place it now.  If using mini usb, wait till later as it goes on the bottom.\\
-To test main 3v3 rail, inject 5v in to 5V line at TP10.  Once that checks out proceed to third page of schematic, and install MCU and the related parts.\\
+inject 5v in to 5V line at TP10, check at header pin for +3v3. ,{{:2014-07-21_00.19.80.jpg?direct&200|}} \\
+Once that checks out proceed to third page of schematic, and install the MCU (IC12) and the related parts.\\
 Dont install the buttons and speaker yet, as they go on the bottom.\\
@@ Line 34: / Line 38: @@
 Once again inject 5V in to TP10, test all the other voltages. {{:2014-07-17_15.43.70.jpg?link&250|}}\\
+Test point values:\\
 TP18 - 3v3\\
 TP19 - 2v5\\