Differences

This shows you the differences between two versions of the page.

--- l12014_proxmark3_oled_build [2014/07/19 15:16] – [Notes] mmca
+++ l12014_proxmark3_oled_build [2014/07/22 01:10] – [Notes] added 3v3 pic mmca
@@ Line 1: / Line 1: @@
 ====== LayerOne 2014 Badge Build ======
+{{ :2014-06-26_22.26.30.jpg?direct&500 |}}
@@ Line 25: / Line 27: @@
 If using micro usb, place it now.  If using mini usb, wait till later as it goes on the bottom.\\
-To test main 3v3 rail, inject 5v in to 5V line at TP10.  Once that checks out proceed to third page of schematic, and install MCU and the related parts.
+inject 5v in to 5V line at TP10, check at header pin for +3v3. ,{{:2014-07-21_00.19.80.jpg?direct&200|}} \\
+Once that checks out proceed to third page of schematic, and install the MCU (IC12) and the related parts.\\
+Dont install the buttons and speaker yet, as they go on the bottom.\\
+Short the two pins of IC7 with a zero ohm resistor like so: {{:2014-07-17_15.43.60.jpg?link&250|}}\\
+Now flash MCU with: {{:layer1_proxmark_oled_flash.zip|L1 PM3OLED Firmware}}\\
+Once again inject 5V in to TP10, test all the other voltages. {{:2014-07-17_15.43.70.jpg?link&250|}}\\
+Test point values:\\
+TP18 - 3v3\\
+TP19 - 2v5\\
+TP20 - 1v2\\
-Dont install the buttons and speaker yet, as they go on the bottom.
-Short the two pins of IC7 with a zero ohm resistor like so: {{:2014-07-17_15.43.60.jpg?link&250|}}