equipment:laser_cutter:upgrades
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
equipment:laser_cutter:upgrades [2023/01/17 20:05] – [Acquired but not yet installed] nz0 | equipment:laser_cutter:upgrades [2023/01/22 16:29] – nz0 | ||
---|---|---|---|
Line 10: | Line 10: | ||
|z autofocus sensor w/bracket installed | |z autofocus sensor w/bracket installed | ||
- | ==== Acquired but not yet installed | + | ^ Acquired but not yet installed |
|RECI W2 Laser Tube | new tube is at the space - will install when the old tube fails| | |RECI W2 Laser Tube | new tube is at the space - will install when the old tube fails| | ||
^ upgrades/ | ^ upgrades/ | ||
+ | |USB camera for lightburn | ||
|quiet duct fan | $120| | |quiet duct fan | $120| | ||
|10600nm protective glasses | |10600nm protective glasses |
equipment/laser_cutter/upgrades.txt · Last modified: 2023/08/22 10:27 by nz0