User Tools

Site Tools


equipment:laser_cutter:upgrades

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
equipment:laser_cutter:upgrades [2022/02/11 12:53] nz0equipment:laser_cutter:upgrades [2023/08/22 10:26] – [Installed and Upgraded!] nz0
Line 1: Line 1:
 ===== Wish List ===== ===== Wish List =====
  
-==== Worn/dead parts that need replacing ====+==== Installed and Upgraded! ==== 
 +^ upgraded| 
 +|new estop switch installed          | 
 +|main power key switch installed     | 
 +|Ruida Controller/control panel installed    | 
 +|Lightburn software installed                 | 
 +|red dot pointer w/bracket installed        | 
 +|z autofocus sensor w/bracket installed      | 
 +|Mahoney CO2 Laser Power Meter Probe | (to measure how much power is actually coming out of our tube)| 
 +|1 pair 10600nm protective glasses          | $36 each pair (the current ones are not for a co2 laser)| 
 +|ameter power usage meter            | 
  
-Needed Item                        Cost as of 2/2022+Acquired but not yet installed ^| 
-|estop switch                        $20-$30| +|RECI W2 Laser Tube                  new tube is at the space will install when the old tube fails|
-|main power key switch               | $20-$30 or replace with non key switch?| +
-|LEETRO Controller/control panel| (see controller below)+
  
-^Not dead yet but sooner or later ^ Cost| 
-|RECI W2 Laser Tube                  | $580| 
  
 ^ upgrades/nice to haves ^Cost| ^ upgrades/nice to haves ^Cost|
-|Ruida Controller/control panel     | $279 or $398 depending on replacement model| +|USB camera for lightburn            | $80 https://lightburnsoftware.com/products/lightburn-camera?variant=13886769889325 
-|Lightburn software                  | $120 (Huge functionality upgrade from the existing software)| +
-|red dot pointer w/bracket           | $28 (could 3d print something and use a 6$ diode)| +
-|z autofocus sensor w/bracket        | $44|+
 |quiet duct fan                      | $120| |quiet duct fan                      | $120|
-|10600nm protective glasses          | $36 each pair (the current ones are not for a co2 laser)| 
 |Rotary tool (y axis replacement)    | $310  (So we can etch round things like glasses and tubes)| |Rotary tool (y axis replacement)    | $310  (So we can etch round things like glasses and tubes)|
-|ameter power usage meter            | ?| 
 |laser on timer                      | ?| |laser on timer                      | ?|
-|Mahoney CO2 Laser Power Meter Probe | $105 (to measure how much power is actually coming out of our tube)| 
- 
  
equipment/laser_cutter/upgrades.txt · Last modified: 2023/08/22 10:27 by nz0