Differences

This shows you the differences between two versions of the page.

--- equipment:laser_cutter:upgrades [2022/02/11 12:53] – nz0
+++ equipment:laser_cutter:upgrades [2023/01/22 16:29] – nz0
@@ Line 1: / Line 1: @@
 ===== Wish List =====
-==== Worn/dead parts that need replacing ====
+==== Installed and Upgraded! ====
+^ upgraded|
+|new estop switch installed          |
+|main power key switch installed     |
+|Ruida Controller/control panel installed    |
+|Lightburn software installed                 |
+|red dot pointer w/bracket installed        |
+|z autofocus sensor w/bracket installed      |
-^ Needed Item                        ^ Cost as of 2/2022|
+^ Acquired but not yet installed ^|
-|estop switch                        | $20-$30|
+|RECI W2 Laser Tube                  | new tube is at the space - will install when the old tube fails|
-|main power key switch               | $20-$30 or replace with non key switch?|
-|LEETRO Controller/control panel| (see controller below)
-^Not dead yet but sooner or later ^ Cost|
-|RECI W2 Laser Tube                  | $580|
 ^ upgrades/nice to haves ^Cost|
-|Ruida Controller/control panel     | $279 or $398 depending on replacement model|
+|USB camera for lightburn            | $80 https://lightburnsoftware.com/products/lightburn-camera?variant=13886769889325|
-|Lightburn software                  | $120 (Huge functionality upgrade from the existing software)|
-|red dot pointer w/bracket           | $28 (could 3d print something and use a 6$ diode)|
-|z autofocus sensor w/bracket        | $44|
 |quiet duct fan                      | $120|
 |10600nm protective glasses          | $36 each pair (the current ones are not for a co2 laser)|
@@ Line 22: / Line 22: @@
 |laser on timer                      | ?|
 |Mahoney CO2 Laser Power Meter Probe | $105 (to measure how much power is actually coming out of our tube)|