equipment:laser_cutter:upgrades
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
equipment:laser_cutter:upgrades [2022/02/11 12:51] – created nz0 | equipment:laser_cutter:upgrades [2023/01/17 20:05] – [Acquired but not yet installed] nz0 | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Wish List ===== | ===== Wish List ===== | ||
- | ==== Worn/dead parts that need replacing | + | ==== Installed and Upgraded! |
+ | ^ upgraded| | ||
+ | |new estop switch installed | ||
+ | |main power key switch installed | ||
+ | |Ruida Controller/ | ||
+ | |Lightburn software installed | ||
+ | |red dot pointer w/bracket installed | ||
+ | |z autofocus sensor w/bracket installed | ||
- | ^ Needed Item ^ Cost as of 2/2022| | + | ==== Acquired but not yet installed ==== |
- | |estop switch | + | |RECI W2 Laser Tube |
- | |main power key switch | + | |
- | ^Not dead yet but sooner or later ^ Cost| | ||
- | |RECI W2 Laser Tube | $580| | ||
^ upgrades/ | ^ upgrades/ | ||
- | |LEETRO Controller/ | ||
- | |Lightburn software | ||
- | |red dot pointer w/ | ||
- | |z autofocus sensor w/ | ||
|quiet duct fan | $120| | |quiet duct fan | $120| | ||
|10600nm protective glasses | |10600nm protective glasses | ||
Line 21: | Line 21: | ||
|laser on timer | ?| | |laser on timer | ?| | ||
|Mahoney CO2 Laser Power Meter Probe | $105 (to measure how much power is actually coming out of our tube)| | |Mahoney CO2 Laser Power Meter Probe | $105 (to measure how much power is actually coming out of our tube)| | ||
- | |||
- | ==== Cutting ==== | ||
- | |||
- | ^ Item ^ Cost ^ Speed ^ Power | | ||
- | | Acrylic | ||
- | | Blue Acrylic | .1181 | 20 | 80 | | ||
- | | MDF | .1181 | 20 | 60 | | ||
- | | Plywood | ||
- | | Rubber | ||
- | | Mylar Sheet | .002 | 10 | 300 | | ||
- | | Cheese | ||
- | |||
- | //Please update this list with UNITS and additional materials after every new cut or test.// | ||
- | ==== Engraving ==== | ||
- | |||
- | ^ Material | ||
- | | Acrylic | ||
- | | MDF | 300 | 10 | | ||
- | |||
- | //Please update this list with additional materials after every new engrave or test.// | ||
- | |||
- | Sample Etches | ||
- | {{: | ||
- |
equipment/laser_cutter/upgrades.txt · Last modified: 2023/08/22 10:27 by nz0