which_bits
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | which_bits [2013/08/13 12:13] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | The set i use is (from precise bits) | ||
+ | |||
+ | * v90,v60,v45 isolation trace bits http:< | ||
+ | * 0.008 0.015, 0.0313, 0.0625 and 0.125 stub ends (end mills) http:< | ||
+ | * 0.80 mm (note metric, all others are inches) router, which is the smallest they have at precisebits http:< | ||
+ | |||
+ | You can do just about any board with that set just about (outside of drill bits), which you'd want in a range. Typical sizes are 0.016 0.032, 0.036, 0.040, 0.125, you'll usually never have the right one you need, so design the board so you do or get lots. http:< | ||
+ | |||
+ | I use the depth rings, but not the bushing, the ZrN coating says it lasts longer, but i have no data. | ||
+ | |||
+ | The bits don't last as long as you might think, so best to double up on everything, they' | ||
+ | |||
+ | http:< | ||
which_bits.txt · Last modified: 2013/08/13 12:13 by 127.0.0.1