laser_stencils
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | laser_stencils [2013/08/13 12:13] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ==== Making Laser-cut Solder Paste Stencils Using Eagle CAD ==== | ||
+ | |||
+ | 1. Open your .BRD file in Eagle CAD 2. Go to " | ||
+ | |||
+ | [[Image: | ||
+ | |||
+ | |||
+ | |||
+ | 5. Select " | ||
+ | |||
+ | 6. Enter a file name and save the .DXF file to the " | ||
+ | 7. Open the .DXF file in Corel Draw. Select " | ||
+ | 8. Resave the file. If you do not open/ | ||
+ | 9. Open the LASER 5.5 software. Select " | ||
+ | 10. Set "Laser Power" to 10%. Set Speed to " | ||
+ | 11. Tape a sheet 2mil Mylar film to a piece of cardboard or MDF. This keeps it flat and also makes the cut pieces come off after cutting. 12. Rotate and/or clone the image to fit multiple stencils on one 8.5x11" | ||
+ | 13. Select " | ||
+ | 14. Hit & | ||
+ | 15. Hit & | ||
+ | 16. Make sure the blower (on power strip) and chiller are turned ON. | ||
+ | 17. Press & | ||
laser_stencils.txt · Last modified: 2013/08/13 12:13 by 127.0.0.1