Differences

This shows you the differences between two versions of the page.

--- l12014_proxmark3_oled_build [2014/07/27 00:18] – [Notes] mmca
+++ l12014_proxmark3_oled_build [2014/08/27 20:57] (current) – [Notes] photo blakangel
@@ Line 1: / Line 1: @@
 ====== LayerOne 2014 Badge Build ======
 {{ :2014-06-26_22.26.30.jpg?direct&500 |}}
+Please use pic above for orientation (click for larger image).\\
@@ Line 13: / Line 15: @@
 Don't place the battery yet.\\
-Use hotair gun for IC1 and U&7.\\
+Use hotair gun for IC1 and U$7.\\
 Do not place (DNP) R55 and R60.\\
@@ Line 42: / Line 44: @@
 TP19 - 2v5\\
 TP20 - 1v2\\
+Use the Silver SV2: {{:2014-08-02_20.00.50.jpg?250|}}\\
+Before installing the OLED display and battery, ensure the proxmark is properly working via USB by installing a jumper wire from F1 (PTC Fuse) to TP10 to provide 5V to the board. Plug into a computer and verify the correct USB VID/PID.
+This is also a good time to install required proxmark3 usb drivers and the proxmark3 application for your OS.
+You need to install a jumper wire for the MOSI signal from the via near the buzzer to the correct pad of SJ1. Refer to the below photograph:
+{{:jumper-wire-proxmark-l1-cropped.png |}}