l12014_proxmark3_oled_build
This is an old revision of the document!
LayerOne 2014 Badge Build
Notes
Please use the following board/schematic and NOT the svn:
Start with the parts on page 1 and page 2 of the schematic.
Don't place the battery yet.
Use hotair gun for IC1 and U&7.
Do not place (DNP) R55 and R60.
C9 should be a 0 ohm resistor (jumper).
R43 should be changed to 110K~120K, ask M for that part.
Jumper JP2 like so:
IC3 is now a 500ma part. CAT6219-330TDGT3 Do not use same part as IC13.
If using micro usb, place it now. If using mini usb, wait till later as it goes on the bottom.
l12014_proxmark3_oled_build.1405797263.txt.gz · Last modified: 2014/07/19 12:14 by mmca